Building the C-Bot 3D printer: Part 29 : Rearranging the Leadscrews
Jump to C-Bot blog index to see all the posts.
The C-Bot build instructions have you create a cantilevered build platform, with two rear leadscrews to drive it up and down. Other designs have modified this to have a triple-leadscrew system where two screws are in the back, and one in the front: This provides for better stability for the cantilevered build platform. I’ve noticed on my larger prints a bit of “bounce/vibration” that happens on the platform as it drops over the lifetime of the print. It would make sense that attaching the front to something would reduce this.
I seriously contemplated going to a triple-leadscrew system, but this would involve buying more hardware, cutting another leadscrew, etc. Not the end of the world, but I’d like to work with what I already have. I got to thinking: Why not just take one of the rear leadscrews and put it in the front?
That’s what I did this afternoon, and so far, it’s worked out really well: I had a long enough 20×40 cutoff I was able to put across the front of the build platform, and some spare printed corner-brackets to mount it in-place. From there, I took the right-rear leadscrew and moved it to the center. Then I took the left-rear leadscrew and moved it to the new front location.
Things noticed so far:
- Build platform is much more rigid.
- It’s easy to raise\lower the front\back for bed leveling by just twisting the leadscrews.
Jump to C-Bot blog index to see all the posts.